How to Fix Error 0x8007045d on Windows 10?

Question

---

How to Fix Error 0x8007045d on Windows 10?

---

Answer 1

---

Were you installing Windows or making a backup of your data and have an error 0x8007045D? Do not worry, I'll explain how you can fix it . Most of the time this error is due to corruption somewhere in the Windows registry. To correct this error, follow the steps below. They will help you to improve the health of your computer system and, ultimately, to solve this error.

HOW TO RUN THE DISK RECOVERY OR CHECKDSK

The error code 0x8007045D can be solved by running the checkdsk scan . This scan helps find corruption of internal files in Windows. To execute the checkdsk, follow the steps below:

NOTE: The X command is used for the drive letter where we have the problem

1. Click on Start
2. In the search box, type CMD and press Enter
3. Enter the following command at the Chkdsk / RX prompt
4. Press Enter
5. Press "Y" to execute a disk check when restarting the PC
6. Close all programs
7. Restart your computer
8. Repeat steps 1-5 and run the disk check of all drives
9. When you are ready, run the backup process again

HOW TO DISABLE PC SECURITY SERVICES

If you are trying to make a backup and you have activated an antivirus or firewall, this may be what is preventing you, since it is one of the causes of error 0x8007045D on your device. Therefore, you must proceed to deactivate your antivirus and firewall before carrying out the process . You can disable your antivirus by following the steps indicated below:

1. Click on Start
2. Go to Programs
3. Open your antivirus or firewall
4. Find the configuration
5. In this section, you usually find the option to deactivate it in most programs of this type.

CHECK THE WINDOWS REGISTRY FILES

Error 0x8007045D can occur when the Windows registry is corrupted. There are programs like CCleaner that can help you. Not only to correct errors in your system, it also improves the stability of your PC. The most important characteristic of a program of this type is that of being able to clean the Registry . Although be careful, if it is not used correctly, it can cause problems.

REDUCE THE VOLUME OF YOUR DISK

This option is another one that can solve the error, using the size reduction technique. Follow these steps to run the disk reduction :

1. Open the Disk Administrator
2. Click on the unit where you want to reduce the size
3. Click on "Shrink Volume" or "Reduce Disk"
4. Follow the instructions that appear on the screen

---

Answer 2

Operating system installed ????. 
is a partition an external disk, internal / usb memory (in conflict) ?? 

* Go to start (windows 7) and in the search rectangle of programs and files type CMD, right click and execute it as administrator. 

* A black window will open (Ms-Dos) write the following command (respecting the spaces). 

Chkdsk / RX 

Note: in the "X" command, write the letter of the hard disk or partition to be analyzed. 
go to my computer and there you will see the letters of all your hard drive or backup partitions. 

1.-Press enter or Enter. 
2.-Press Y (accept), when you are asked to scan the disk the next time the system is rebooted. 

3.-Close all the programs and restart ... 

Note: During the reboot process, Windows will look for errors in the disk and correct them, upon completion Windows will start. 

4.-Repeat the same Procedure from 1 to 3 in all the backup partitions or disks that your team has. 

Download and install Auslogic Registry cleaner 
http://www.auslogics.com/en/software/registry-cleaner/ download / 

* Open auslogic registry Cleaner and in the column on the left side activate or enable all the boxes. 
* Close Program. 
* Enter to fail-safe mode. 
* Open asulogic, click on scan and at the end click on Repair. 
* Restart