Ways to fix "connection error 651 windows 10"

Question

---

Hello friends, Taringueros!

Good to start, in this post I will explain how to solve a very common problem that occurs in Windows 7 (Especially in Notebooks that are connected to a network by Wi-Fi, when you want to connect by broadband, the PC to the network jumps this error, for example my case), which is an error that occurs when we try to connect to the Internet through a broadband modem. They say that the error is because in this windows, the Raspppoe.sys file. Well I personally had this problem and in my case this file did not produce the problem, I could solve it in a very simple way.

The problem apparently on my computer was that windows had disabled the local area connection.

---

Answer 1

---

1) You must "Run" windows, it opens with Windows + R. 

2) In this instance we must have the "Run" windows open, then in that box that appears there we write "ncpa.cpl" (without the quotes) and press enter. 

3) Once step 2 is executed, a window will open with our available network connections. In this window we go to "Local Area Connection" with click right and then go to properties. 

4) If "Internet protocol Version 6" is checked, we distil them. 

5) Then we go to "Internet Protocol Version 4", we label it and go to properties and select "Use the following IP address" and complete the following. 

IP address: 192.168.1. 



Default gateway: 192.168.1.1 

And in preferred DNS service we put the following: 

192.168.1.1 

Finally, the alternative DNS is left blank. 

6) Then we accept and leave 

7) Now we create our broadband connection from our internet server, but we do not connect our connection yet. 

8) We return to our broadband connection, in the same way as we did in points 1 and 2. 

9) Right click on "Local Area Connection" and select ACTIVATE. 

10) And finally we connect our network through the connection that we created in point 7 and Ready! 

---